How to handle the broken wire condition of Hangzhou pulley wire drawing machine?

How to handle the broken wire condition of Hangzhou pulley wire drawing machine? The Hangzhou pulley wire drawing machine is suitable for surface wire drawing treatment of various flat plates. Many users have reported that when using the triangular Hangzhou pulley wire drawing machine, frequent wire breakage occurs during the metal wire production process, which affects the processing and results in loss. They want to find a solution. Before proposing a solution, we first need to understand the reasons behind it. Only by understanding the reasons can we effectively address this issue.

The control system of the Hangzhou pulley wire drawing machine can provide a very precise and bright angular velocity, which is valuable. However, for equipment like the Hangzhou pulley wire drawing machine, the system software needs to be very high for speed operation.

The software of all systems of Hangzhou pulley wire drawing machines is relatively messy, and the control system rules are harmonious in the middle of each motor. The software of the Hangzhou pulley wire drawing machine system is operated by four servo motors, which can fully achieve real-time interaction between data and information. In order to better ensure the area on the side of the railway track according to the optimization algorithm, the power lines of this bank can be quickly calculated according to the rules. The flexible use of internal fixed components of servo motors greatly eliminates the total time estimated by the traditional Hangzhou pulley wire drawing machine control system based on the calculation of the controller itself. Subsequently, the command is sent to the controller to ensure the operation of the Hangzhou pulley wire drawing machine, in order to minimize the delay time based on the control board.

1. The drawing die of the Hangzhou pulley drawing machine will have a larger diameter area during continuous production due to normal wear and tear.

2. Due to quality issues with various rod materials. During the production process, the rod material exhibits quality defects irregularly, which causes the metal wire to be pulled apart by various unpredictable tensions during wire drawing deformation. This situation is less common when the rod material is good.

3. Due to the instability of the annealing current during production, the current suddenly increases, and the metal wire is pulled apart or fused by sudden strong currents during the annealing process.

The handling method for the broken wire situation of the Hangzhou pulley wire drawing machine mentioned above: Before production, it is necessary to conduct sufficient self inspection on the rod material to be produced, timely discover the quality defects of the rod material, and find corresponding countermeasures based on different conditions, or reduce the drawing speed of the triangular Hangzhou pulley wire drawing machine, or eliminate the defects in this section. During production, we constantly investigate whether the annealing current of wire drawing is normal. Especially when we just start up, we should pay special attention to the change of annealing current. We should adjust the size of annealing current according to the change of wire speed, so that the annealing current slowly increases with the increase of wire speed, and ensure the normal operation of Hangzhou pulley wire drawing machine.