Operation requirements and maintenance matters for Hangzhou pulley wire drawing machine!

Operation requirements and maintenance matters for Hangzhou pulley wire drawing machine! Before processing the Hangzhou pulley wire drawing machine, the operator should carefully read the drawings and relevant technical information, and understand and grasp them. During processing, it is necessary to correctly select and confirm the drawing direction, drawing surface, etc., and operate according to the rules and requirements. Also, it is necessary to maintain the appearance of the workpiece to prevent scratches on the Hangzhou pulley wire drawing machine and avoid waste.

The products processed by the Hangzhou pulley wire drawing machine should be handled with care and maintained in layers to avoid damage to the products. The exterior and surroundings of the Hangzhou pulley wire drawing machine equipment should be kept clean, tidy, and hygienic; Check the gas supply pipeline, joints, and sand belts to see if they are outstanding and if adjustments are needed; Drain the accumulated water from the air filter and smooth the bearing seat of the Hangzhou pulley wire drawing machine.

In addition to daily maintenance, it is also necessary to check whether the tension of the conveyor belt and sand belt of the Hangzhou pulley wire drawing machine is suitable and whether adjustments are needed; Whether the operation of the Hangzhou pulley wire drawing machine is correct and safe, ensuring that the Hangzhou pulley wire drawing machine can always maintain a good working condition.

The Hangzhou pulley wire drawing machine is used for general plastic. The Hangzhou pulley wire drawing machine has higher requirements for drawing gold wire, and the entire system is relatively complex. The control equipment requires coordination between various motors. The Hangzhou pulley wire drawing machine system is controlled by four servo motors, fully meeting the real-time interaction between data and the servo for real-time data exchange between each axis of each group.

In the system view that requires the interaction between the fast motor shafts, in order to ensure the local calculation of the track side siding according to the algorithm, it is required that the wires of the line can be quickly calculated. We also fully utilize the internal firmware function of the servo, which greatly eliminates the calculation of the orientation of the line in the control system of the traditional plastic Hangzhou pulley wire drawing machine by self driving the motor siding through the calculation of the driver itself, Then, due to time delay, it is sent to the driver to ensure the operation of the Hangzhou pulley wire drawing machine, in order to minimize the delay passing through the controller as much as possible.