Heating method and speed control system of Hangzhou pulley wire drawing machine!

Heating method and speed control system of Hangzhou pulley wire drawing machine! The Hangzhou pulley wire drawing machine is used for general plastic. The Hangzhou pulley wire drawing machine has higher requirements for wire drawing, and the entire system is relatively complex. The control equipment requires harmony between various motors. There are many ways to heat the Hangzhou pulley wire drawing machine, some of which use resistance wire for heating, while others use electromagnetic heating.

The Hangzhou pulley wire drawing machine utilizes heat transfer to heat the resistance wire. This is because the iron sheet heats up and transfers the heat into the material barrel. During this process, some of the heat is consumed along the way, and another part is dissipated in the air, resulting in waste of heat energy. This is also equivalent to wasting electrical energy. The function of the electromagnetic heater of the Hangzhou pulley wire drawing machine is to heat and save energy for plastic machinery, which can completely replace the old-fashioned resistance heating.

The main method is to wrap a layer of insulation cotton on the material barrel, which can reduce the consumption of heat energy. Then, wrap another layer of electromagnetic heating coil on the insulation cotton, and when the Hangzhou pulley wire drawing machine is powered on, the iron molecules inside the material barrel will operate strongly, causing the material barrel to heat up. Therefore, compared to traditional methods, this method is more energy-efficient, The efficiency of the Hangzhou pulley wire drawing machine is also higher, and switching from the traditional resistance type to the current electromagnetic heating type can save about 30% of electrical energy.

The Hangzhou pulley wire drawing machine system has a high demand for speed control, and the Hangzhou pulley wire drawing machine control system can provide a very accurate and lubricated linear speed. Four servo motors are selected for control, which meets the real-time interaction between data and real-time data exchange between each axis in each group. In order to calculate the lateral line according to the trajectory of the algorithm, it is necessary for the wires of the line to be able to be quickly calculated by the driver itself, which greatly eliminates the need for calculating the direction of the line in the traditional control system of Hangzhou pulley wire drawing machines,

Then, due to a delay in time, it was sent to the Hangzhou pulley wire drawing machine driver to minimize the delay through the controller. Hangzhou Wire Drawing Machine Manufacturing Co., Ltd. was founded in 1975, providing inverted wire drawing machines, straight wire drawing machines, water tank wire drawing machines, Hangzhou pulley wire drawing machines, non-ferrous metal wire drawing machines, straightening and cutting machines, auxiliary equipment for wire drawing machines, and non acid pickling and rust removal equipment. It is one of the earliest manufacturers of Hangzhou pulley wire drawing machines in Zhejiang Province. Please feel free to inquire.